product bulletin dimensions ? millimeters (inches) see capacitance value table below for thickness dimension. outline drawing
f-9078c 08/06 surface mount ceramic chip capacitors ? c0201 series - x5r dielectric eia size metric size l w b s code code length width bandwidth separation 0201 0603 0.6 (.024) 0.03 (.001) 0.3 (.012) 0.03 (.001) 0.15 (.006) 0.05 (.002) - capacitance value capacitance value (uf) kemet part number voltage capacitance tolerance thickness qty 7" reel 0.01 c0201c103k4pac 16 k,m 0.3 (.012) 0.03 (.001) 15,000 0.10 c0201c104k9pac 6.3 k,m 0.3 (.012) 0.03 (.001) 15,000 c 0201 c 104 k 9 p a c style c - ceramic size code see dimension table specification c - standard capacitance code, pf first two digits represent significant figures. third digit specifies number of zeros. 100 pf = 101. (use ?9? for 1.0 through 9.9 pf) (use ?8? for 0.1 through .99 pf) capacitance tolerance k = 10% voltage 9 = 6.3v temperature characteristic designated by capacitance change over t p = x5r (15%) (-55c +85c) emperature range end metallization c = standard (tin-plate nickel barrier) failure rate level a = not applicable capacitor ordering information 4 = 16v m = 20%
? kemet electronics corporation ? p.o. box 5928 ? greenville, sc 29606 (864) 963-6300 ? www.kemet.com f-9078c 08/06 electrical parameters as detailed in the kemet surface mount catalog f3102 for x5r, with following specific requirements based on room temperature (25c) parameters: ? operating range: -55c to +85c, with no-bias capacitance shift limited to 15% over that range. ? insulation resistance (ir) measured after 2 minutes at rated voltage @ 25c: limit is 500 megohm microfarads or 10000m , whichever of the two is smaller. ? capacitance and dissipation factor (df) measured at 1 khz and 1 vrms. df limit is 10% max.** ** please refer to individual specifications. soldering process these components are suitable for reflow only. all parts incorporate the standard kemet barrier layer of pure nickel, with an overplate of pure tin to provide excellent solderability as well as resist- ance to leaching. marking these chips will be supplied unmarked. in general, the information in the kemet surface mount catalog f3102 applies to these capacitors. the information in this bulletin supplements that in the catalog.
|
